Publicité
Les langues disponibles
Les langues disponibles
Built-in opening
requirements &
dimensions
All dimensions ±1/8" (3 mm)
A solid soffit or two, 2" x 4" x 32"
(5 cm x 10 cm x 81 cm) wood boards
to cover the width of the compressor
cover are required above the
refrigerator to prevent tipping
during use.
If solid soffit is more than 1 inch
(2.5 cm) above refrigerator, two
2"x 4" x 32" (5 cm x 10 cm x 81 cm)
wood boards must be installed on
the wall 1/4 inch (6 mm) above the
refrigerator cover. The bottom
surface of the boards should be
84 inches (213 cm) from floor. Boards
must be long enough to fully cover
width of compressor cover.
The built-in refrigerator can be
installed:
• recessed in the cabinet opening.
• at the end of cabinets using a side
panel to enclose the side of the
refrigerator.
Select one method and use dimensions
given. Dimensions shown provide
0" (0 cm) clearance.
All manuals and user guides at all-guides.com
Mark stud
locations on
(203-229 cm)
above floor.
Height
Install side panel (optional)
support board on rear wall
if opening depth is
25" (63.5 cm) or more.
Water line must
provide 15-100 psi
(103-690 kPa) water
pressure. Rough in
water line before
installing
refrigerator.
Depth
Floor: Must support refrigerator,
contents, and door panels.
Opening dimensions
Width min.
35-1/2" (90 cm)
Height min.
83-1/4" (211.5 cm)
Height max.
84-3/4" (215 cm)
Depth min.
23-1/2" (60 cm)
rear wall
80" - 90"
Grounded electrical
outlet location
Grounded electrical
outlet is required.
Width
Water line
location can be
through floor
or wall.
3"
(7.6 cm)
2" (5 cm)
10"
(25 cm)
8"
(20 cm)
7"
(18 cm)
77"
(196 cm)
7"
(18 cm)
5-1/2"
(14 cm)
1/2" (12 mm) hole for
plumbing can be
located anywhere
within shaded area.
6"
(15 cm)
Page 3
Publicité
