Black & Decker NW36XXY Mode D'emploi page 5

Warning! Keep electrical appliances out
of reach from children or infirm persons.
Do not let them use the appliances
without supervision.
Features
1. On/off switch
2. Dust bowl
Fig. A
3. Crevice tool
4. Wet pick-up accessory
Unpacking
Identifying your product
The model design can be determined
from the suffix codes used in the
catalogue number. The following
catalogue numbers are described in this
manual: NW36XXY/NW48XXY
The suffix code XX corresponds to the
following designs:
00: stick handle, no accessories supplied
03: loop handle, supplied with crevice
tool and brush tool
60: loop handle, supplied with crevice
tool and wet pick-up accessory
The suffix code Y is used to identify the
range of colour options. The suffix code
Y represented by the letter N is used for
models with an NiMH battery.
Installation
Fitting the wall hook to the wall
(fig. B)
The wall hook can be fitted to the wall to
provide a convenient storage and
charging point for the appliance.
Fitting the charging base to the
wall (fig. C1 & C2)
The charging base can be placed on a
worktop or fitted to the wall to provide a
convenient storage and charging point
for the appliance.
ENGLISH
Assembly
Fitting the accessories (fig. A & D)
The appliance is supplied with the
following accessories:
a crevice tool (3) for confined spaces

a wet pick-up accessory (4) for wet

spills
To fit an accessory, proceed as follows:
Take the accessories from the

appliance.
Insert the appropriate accessory into

the front of the appliance.
You may refit the other accessory by
clicking it into the accessory holder.
To refit both accessories:
Push the accessories down until they

click into place.
Use
The appliance can be charged while

placed on a worktop or hung on the
wall using the wall hook provided.
Before first use, the battery must be

charged for at least 16 hours.
Leave the appliance connected to the

charger whenever it is not in use.
Charging the battery (fig. C1 & C2)
Make sure that the appliance is

switched off. The battery will not be
charged with the on/off switch in the
on position.
Fit the appliance properly on the

charger aligning the arrow on the
charger with the split of the appliance.
Plug in the charger. Switch on at the

mains.
Leave the appliance to charge for at

least 16 hours.
Whilst charging, the charger may become
warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
Warning! Do not charge the battery at
ambient temperatures below 4 °C or
above 40 °C.
5