Teka CGW LUX 60 TC 4G AI AL CI Mode D'emploi page 14

8) ELECTRICAL CONNECTION
IMPORTANT: the appliance must be
installed following the manufacturer's
instructions. The manufacturer will not be
liable for injury to persons or animals or
property damage caused by an incorrect
installation.
The electrical connection must be made in
compliance with the standards and legal
provisions in force.
Before making the connection, ensure that:
- the voltage matches the value shown on the
specification plate and the section of the wires of
the electrical system can support the load, which
is also indicated on the specification plate.
- the socket or system has an effective earth
connection in compliance with the standards and
legal provisions currently in force. We cannot
accept any responsibility for failure to observe
these provisions.
When the appliance is connected to the power
supply via socket:
- fit a standard plug suited to the load indicated on
the label to the power cable "C" if necessary.
- Connect the wires in compliance with the diagram
in fig. 10, ensuring that the following are observed:
letter L (phase) = brown wire;
letter N (neutral) = blue wire;
earth symbol = green-yellow wire.
- The power cable must be positioned so that it
does not reach an over-temperature of 75 K in
any point.
- Do not use reductions, adapters or shunts for the
connection, as they could make false contacts
causing hazards due to overheating.
- The socket must be accessible after fitting.
When the connection is made directly to the
electricity main:
- insert an omnipolar switch between the appliance
and the power network, in a size suited to the load
of the appliance, with a minimum aperture
between contacts of 3 mm.
- Remember that the earth cable must not be
interrupted by the switch.
- The electrical connection may also be protected
with a highly sensitive differential switch.
We strongly recommend that you connect the
appropriate green-yellow earth wire to an efficient
earth system.
All manuals and user guides at all-guides.com
INSTALLATION
Before performing any service on the electrical
part of the appliance, it must absolutely be
disconnected from the electrical network.
The manufacturer declines all responsibility for
damages suffered by people and items due to
failure to observe the aforementioned indications,
or deriving from interference with a single part of
the appliance.
If the installation requires modifications to
the home's electrical system or if the
socket is incompatible with the appliance's
plug, have changes or replacements
performed by professionally-qualified
person. In particular, this person must also
make sure that the section of the wires of
the socket is suitable for the power
absorbed by the appliance.
WARNINGS:
all our appliances are designed and built in
compliance with the European standards
EN 60 335-1, EN 60 335-2-6 and EN 60 335-2-102
plus relative amendments.
The appliance is compliant with the indications
of the following European Directives:
- CEE 2004/108/CE related to electromagnetic
- CEE 2006/95 related to electrical safety.
14
compatibility.
FIG. 10