Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
USE
1) BURNERS
On the surface of the hob, there is a serigraphic figure above each knob, indicating the burner to which the
knob refers. After turning on the gas at the main or opening the valve on the gas bottle, light the burners as
indicated below.
Switching on the Hob
To switch on the hob, press the ON/OFF button constantly for at least 2 seconds. The hob will come on and
the displays related to the burners will show level zero, corresponding to the status of burners off.
Lighting a burner
To light a burner, press and release the + button of the burner you wish to light. You have 4 seconds to
press the + button again to light the burner at level 7. The control system will now make a maximum of 3
attempts at intervals of 10 seconds.
Should the burner fail to light after the third attempt, it locks and the corresponding Led displays the letter
"b". To release the burner, see the relative procedure further ahead.
Every burner for which the relative timer has not been programmed will switch off automatically after 4 hours
of constant operation.
The burner is indicated as being on by the relative digit which will remain active at the flame level selected
for the whole time the burner is on.
Regulating the burner flame level
With the burner lit, to increase the capacity level you must press the + button, while it is necessary to press
the - button to reduce the capacity level. To obtain a continuous variation in the capacity level, it is sufficient
to keep the + or - button pressed and release it at the level required. The capacity level varies from 1 to 7.
Switching off a burner
To switch off a burner it is necessary to simultaneously press the respective + and – buttons for a brief
instant, or use the – button to take the burner to level 0. If the hob is switched off, the corresponding digit
will display the flashing letter "H" (hot) for a few minutes, while if the hob is switched on, the flashing
symbol "H/0" will indicate that the burner is hot. The length of time for which the symbol flashes is purely
indicative, as there can be differences due to conditions of use.
Switching off all the burners and the hob
To simultaneously switch off all the burners, all you have to do is briefly press the ON/OFF button. This
switches OFF the hob.
Programming the switch off time of a burner
Warning: the user must be present constantly while the hob is in use.
It is possible to independently programme a time after which each burner will switch off automatically.
To programme the timer of a burner: switch on the hob using the ON/OFF button, activate the burner to
be programmed using the + button, choose the flame level required using the + and – buttons and press
the Clock button (11) several times in order to reach the burner to be timed. The timer display will indicate
0.00.
The figure to the left of the dot will indicate the hours, while that to the right will indicate the minutes.
Pressing buttons 12 and 13 (- and + of the Clock programming), the display will start flashing, making it
possible to increase or decrease the number of hours or minutes of operation from 0 to 4 hours. When
the programming operation is complete, the display will stop flashing, the time will be displayed and the
corresponding led will be lit. No confirmation is required.
When programming the time, it is possible to zero the current setting at any time by pressing buttons 12
and 13 together (- and + of the clock programming). A time equal to zero deactivates the burner timer.
5
Publicité
