Technoline WS 9218 Manuel D'instructions page 15


For best measuring, place the outdoor sensor outside and protected
from rainfall, strong winds and direct sunlight.

Transmissions between receiver (station) and transmitter (sensor) can
reach up to 100 m in an open area. In open areas there are no
interfering obstacles such as buildings, trees, vehicles, high voltage
lines, etc.

When powering or resetting, the device goes into radio reception mode
for 3 minutes. The signal strength icon "
Outdoor sensor channels

Press the "SENDER" button to view the outdoor sensor channel 1, 2 or
3 on the display. "1", "2" or "3" will be displayed under signal strength
" " accordingly.

Only one sensor can be connected to each channel at a time.

To connect a sensor to a certain channel, select the channel 1, 2 or 3
on the channel switch on the backside of the outdoor sensor before
starting it. Select the corresponding channel on the station and hold
the "SENDER" button for 3 seconds to receive transmission manually.
Radio controlled time & time signal receiving mode

3 minutes after batteries are inserted or station is reset and main unit
finishes receiving the transmission from outdoor sensor, the clock
automatically starts to scan for the DCF-77 time signal. The time signal
reception icon"
flashes，
indicating active DCF
signal reception

The clock automatically scans the time signal at 1:00, 2:00, 3:00, 4:00,
5:00 every day to maintain accurate timing. If reception fails on all
times, scanning stops ("
starts a next attempt on 1:00 of the next day.

The clock can be set to scan the time signal manually by holding the
"▼" button for 3 seconds. Each reception takes about 7 minutes. If
receptions fail, scanning stops.

Manually stop scanning by holding the "▼" button for 3 seconds.
" flashes on the LCD.
stays on and
flashes,
indicating successful
signal reception
" on LCD disappear) on this day and
EN4
" is displayed on LCD.
disappears,
Indicating failed signal
reception