Publicité
Les langues disponibles
Les langues disponibles
X
Laser detector power off, Level laser,
Spin mode
4. Locate the laser beam, using the red
sensor panel on the RCR1. As the laser
beam is approached, a single arrow points
in the direction of the beam. The base unit
emits sounds to aid in locating the laser
beam:
• Rapid beep - Indicates that the laser
detector is pointed overly high or far to
the left or right.
• Continuous tone - Indicates that the
laser detector is pointed directly toward
the laser beam.
5. Center the beam by moving the laser
detector in the direction of the arrow.
When the beam is aligned with the center
of the detector panel, both arrows on the
LCD display are lit and the beep is
continuous, indicating that it is properly
centered.
Switching on the tool
Tool leveled in/ready
for operation
Self-Leveling range
exceeded
Leveling range of the
vertical laser exceeded
Tool In stand-by
operation
Battery voltage for
operation
All manuals and user guides at all-guides.com
Note: Laser detector orientation depends on
whether it is being used to locate the level or
plumb laser beam.
6. To turn off the RCR1, press its power
Charge-control Indicator
When the symbol for the battery indication 37
is indicated on the display 17, the laser
receiver can still be operated for approx. 4
hours.
LED Indications
LED
Green
Yellow
5h
Continuous lighting and audio signal
Flashing and single audio signals
-17-
Level laser detection
On/Off button. There is a double beep for
confirmation, the LCD display becomes
blank, and the lasers shut off.
Red
Plumb laser detection
Publicité
