La Crosse Technology 308-1425CA Manual D'instructions page 4

Detailed Setup: Weather Station and Remote Sensor
STEP 1:
Insert the 5-volt A/C power adapter into the designated area on the
•
back of the weather station.
Plug the A/C power adapter into a wall outlet for continuous backlight
•
(ON/OFF), and dimmer feature.
STEP 2: (optional battery operation)
Slide tab to down and pull out to remove the battery cover.

Insert three new AAA Alkaline batteries into the back of the weather

station. Observe the correct polarity (see marking inside the battery
compartment).
The weather station will light up and show indoor temperature, humidity and time.

(Backlight will illuminate for 10 seconds when using only battery power with a

press/release of the SNOOZE/LIGHT button)
STEP 3:
• Ensure that the transmitter is within 10 feet of the weather station.
Remove battery cover from transmitter. Slide the battery cover down and lift off the
•
front.
Insert two new AA batteries into the TX141TH-Bv3 transmitter. Observe the correct
•
polarity.
Within three minutes, the Weather station will show readings in the remote temperature
•
area on the LCD.
Note: Use Alkaline batteries (or Lithium for temperatures below -29°C/-20°F).
The weather station
has 5 buttons up the
right side and 2
buttons on the front.
Setting-
• Press to decrease values during setting.
• Hold 2 seconds to quickly adjust values.
Default Time Display-
Press to display minimum temperature/humidity.
•
Hold 2 seconds to clear minimum temperature/humidity memory.
•
Temperature Alert-
• Press to disarm alerts
Default Time Display-
Press to start or stop a WWVB time signal search
•
Hold for 3 seconds to set time/calendar, etc.
•
Model: 308-1425CA
Button Functions
▼ (Down) Button
TIMESET Button
https://www.lacrossetechnology.com/308-1425ca Page | 4