Drive DeVilbiss Healthcare MED AIRE DUO WAVE Mode D'emploi page 13

• Use this product only for the purpose described in the
instructions for use.
• Operate the device only with the specified voltage
(230 V/50 Hz).
• The unit should not be covered => Risk of overheating!
• Connect the device only to the mattress intended for it.
• This device is safeguarded against electrical shock
according to the specifications for type BF devices!
Product protection class I
• Do not allow the system to come into contact with
sharp objects (knives, scissors, cannulas, etc.).
• This device should not be disposed of with household
waste. More information is available from local waste
management companies.
• When using side rails on adjustable beds for disabled
persons, a sufficient distance between the top edge
of the positioning system and the upper end of the
bed rail must be ensured. (220 mm according to DIN
1970:2000). If necessary, corresponding side rail risers
should/must be attached to protect the patient.
• Every serious incident which occurs in connection with
the product must be reported to the manufacturer and
the competent authority of the member state in which
the user and/or patient is located.
EMC
This product meets the protection requirements listed in
the council directive on the approximation of the laws
of the member states on electromagnetic compatibility
(EMC, IEC 60601-1-2). However, mutual interference bet-
ween electrical devices, particularly when mobile tele-
phones are used, cannot be completely ruled out under
certain conditions.
Setting up the system
The Med Aire DuoWave is placed on the existing
mattress. Alternatively a 4- or 5-cm high foam pad can
also be placed in the pouch provided.
The existing standard or hospital bed mattress is thus no
longer needed.
• Take the Med Aire DuoWave alternating pressure sys-
tem out of the packaging.
• Check the contents for completeness and any visible
damage.
• Place the alternating pressure system on the mattress
in the standard or hospital bed. The foot end is marked
with 2 feet.
Drive Medical GmbH & Co. KG | As per: 28.07.2023 | Errors and alterations excepted
• Secure the mattress replacement system using the
available straps to the movable parts of the slatted
frame to avoid impairing the functionality of the system
and the adjustable slatted frame.
• Place the unit using the hooks provided at the foot
end, on the floor, or on an even surface.Place the unit
using the hooks provided at the foot end, on the floor,
or on an even surface
Now attach the connection hose to the unit (photo 2).
Important! The connection hose must audibly click into
place in order to prevent an unintentional separation
between the unit and the mattress! Kinking or twisting
the connection hose must be avoided.
Now the Med Aire DuoWave is ready for use.
EN
Instructions for use DUO WAVE
13