Swegon ESENSA Instructions D'installation page 5

6. Coil installation in unit
RIGHT VERSION
picture 4
7. Temperature sensor connection
picture 5
picture 6
Control board
picture 7
We reserve the right to alter specifications.
The waterbased coil must be located horizontaly into the
suitable tray (component M - Picture 3 - page 4) and pushed
to the bottom of the unit (picture 4).
The tubes must be oriented facing the door of the unit and
oriented upwards (picture 4).
The sensor must be attached to the lamellas of the coil.
To do this :
• Connect the sensor nut and the clip by unscrewing/
screwing (picture 5),
• Press manually the flat side of the clip, or with pliers, to
open the claws,
• Attach the clip to the coil lamellas (picture 5),
• Pass the sensor cable through the retaining clips, on the
unit tray, to the electrical cabinet (picture 5),
• Then drill a hole in the entry grommet (component C1/
C2 - Picture 3 - page 3). Pass the sensor cable through
the grommet to reach the electrical cabinet (use
needle-nose pliers for ease of installation) (picture 6),
Pull the sensor cable towards the main board.
• Use fasteners to hold the sensor cable in place with the
other cables already present,
• Connect the connector to terminal X11 according to the
wiring diagram (picture 7).
MULTI.ESENSA.IBA.230726
www.swegon.com 5