Swegon ESENSA Instructions D'installation page 2

Internal postheating waterbased coil
Table of content
1. Installation video
2. General information
3. Control configuration
4. Kit and recommended tools
5. Option location
6. Coil installation
1. Installation video
Click here to open link
2.General information
The component of the option will be delivered separately from
the unit and must be installed by the installer.
Electrical cables must be adjusted to the unit. Connect length
to avoid any damage inside the unit.
The waterbased coil will be used to postheat the air.
3. Control configuration
In addition to installing and connecting the option, configure
the unit's option in the hand controller HMI using the
commissionning manual.
2 www.swegon.com
7. Temperature sensor connection
8. Pipes connection
9. Circulation pump electrical connection
10. 3 ways valve pipe/cable/connecton
11. Digital outputs
MULTI.ESENSA.IBA.230726
The document was originally written in English.
We reserve the right to alter specifications.