ADURO 22 Serie Mode D'emploi page 34

2.3 Connection to a brick chimney
If the stove is being connected to a brick chimney you should use the rear outlet or a curved flue pipe via the
top outlet. After measuring, a hole is made in the chimney in which the pipe sleeve is placed, and stove
mortar is used to seal it in place. The stove is placed in position, and the flue pipe is put in place. A thin
gasket is placed between the flue pipe and the pipe sleeve to seal the joints. The flue pipe should protrude
into the pipe sleeve but must not block the opening in the chimney (see the illustration below). You may
benefit from putting a slim gasket between the flue on the stove and the flue pipe.
The stove can be connected to a chimney to which other heat sources are connected.
Applies to Aduro 22.4 Lux:
Aduro 22.4 Lux must be mounted onto brick chimneys including insulated chimney elements. The stove
cannot be mounted directly to a brick chimney without insulated chimney elements or directly onto insulated
chimney elements as shown below:
2.4 Attachment / hanging of Aduro 22.4 Lux
Aduro 22.4 Lux must be installed on a non-flammable wall. The stove is being delivered with a wall bracket
which must be properly fastened to the wall before mounting the stove (find instructions for mounting the
bracket at the back of this user manual). You may consult your normal supplier of building materials about
suitable attachment materials for the stove/wall before the mounting. ONLY USE FIXING MATERIALS
WHICH CANNOT MELT. If you have any doubts about the requirements, please consult your chimney
sweep who will inspect the stove.
When the wall bracket is mounted and fastened correctly, the stove can be pushed into place. The stove can
now be fastened to the wall bracket with a safety bracket on top of the stove (see picture 1) and a safety
plate under the bottom (see picture 2).
34