Publicité
Les langues disponibles
Les langues disponibles
TOOLS NEEDED FOR INSTALLATION
PARTS SUPPLIED FOR INSTALLATION
PARTS NEEDED FOR INSTALLATION
For non-vented installations only,
FILTER1
part #
For recirculating installations
must be installed
plastic vent grate
terminate into a dead air space.
vent grate
cabinet
6" round
duct
hood
The rangehood can be ducted vertically through a 6" round vent. The unit can also
venting position. FIGURES 1 shows vertical installations for this unit. FIGURE
2 shows recirculating installation.
The Cristal 24" requires 6" round ductwork. To ensure that the blower performs
to its highest possible capacity, ductwork should be as short and straight as
possilbe.
The ductrun should not exceed 35 feet if ducted with
the required minimum of 6" round duct. Calculate
the length of the ductwork by adding the equiva-
lent feet in FIGURE A for each piece of duct in
the system An example is given in FIGURE B.
elbows. Make sure that there is a minimum of
24" of straight duct between elbows if more
than one is used. Do not install two elbows
together.
as far away
as possible.
DUCTING
CARE
CLEANING METAL SELF- SUPPORTING GREASE FILTERS
FIGURE 1
RECIRCULATING INSTALLATIONS
, Charcoal Filters
supplied with the rangehood can be used to cover the duct opening. This duct work must not
Activated charcoal filter (Recirculating version)
ceiling
REPLACING THE ACTIVATED CHARCOAL FILTER
cabinet
20 W halogen light.
FIGURE 2
PLAN THE DUCTWORK
Grease filters
vent grate
B
6" round
duct
Lighting
LIGHT REPLACEMENT
hood
Wall Cap
FIGURE A
9 Feet Straight Duct
Wall Cap
Total System
FIGURE B
Some ductwork
ceiling
FIGURE 2A
A
FIGURE 2B
Version 09/12 - Page 5
3.0 feet
5.0 feet
12.0 feet
0.0 feet
9.0 feet
10.0 feet
0.0 feet
19.0 feet
Publicité
