Wolf Garten UV 30 EV Mode D'emploi page 13

Operation
Operating times
Please check noise abatement regulations prevailing in your
country.
Inserting power cable into cable holder (Fig. )
Insert the power cord into the strain relief as shown in the
illustration.
Connecting to the mains
(230 Volts, .C., 50 Hz)
The mower operates from any normal household mains
supply, provided with a 16 mps. fuse.
Note: Use a residual current device (RCD) rated for a
residual current not greater than 30 m .
djust operating depth (Fig. B)
Only with motor switched off and non-mowing aeriating roller.
The operating depth must be adjusted to the corresponding
grass and ground conditions.
• Move operating lever towards front (Fig. B, 1).
• djust operating depth with turn handle to the desired depth (+).
eriating test:
- Pull operating lever up again.
- Start tool (Fig. C).
- Push operating lever slowly forward (Fig. D).
- Move tool slowly into operating direction.
- On hearing stones being hit or blocking of the motor imme-
diately switch off tool.
- Turn rotating handle 1–2 rotations towards the left (–) - (One
revolution corresponds to 1,5 mm.)
- Start aeriating test again.
• When used regularly the aeriating depth may be adjusted
according to the wear of the blade (+).
Maintenance
Maintenance
Remove spark plug/mains plug cap before attemting any
work to the unit.
Clean the unit thoroughly with a brush after each use. Do not
spray with water. Store unit in a dry room.
All manuals and user guides at all-guides.com
Recommended working heights
Starting up the engine/Scarifying
ttach grassbox* (Fig. F)
well kept lawns with stone-free, soft ground
• Set tool exactly to ground height
stony, untidy lawns
• Set tool to ground height
• Increase working height if stones are thrown up
unkempt, extremely mossy lawns
• Start with a high working height
• Do not overload appliance (increase working height if motor
blocks)
• Cut vertically and crossways several times
• Re-sow with WOLF >>Loretta<< lawn seeds
1. Depress button (Fig. C, 1) and hold.
2. Lift up bar (Fig. C, 2) and release button (Fig. C, 1).
3. Place lever (Fig. D) slowly into forward position.
4. Switch-off motor: Release bar (Fig. C, 2).
Important: Place the cable firmly off the lawn or on the
already cut side of the lawn when starting to mow.
Turning (UV 32 EV)
The cable relief holder enables you to move the cable from
one side of the handle frame to the other. Thus you ensure
that the cable always trails on the ride of the lawn already cut
– and not in front of the machine (Fig. E).
Lift protective flap, hook grassbox with the hooks provided into
the holes in the chassis (see arrow), reattach protective flap.
*Grassbox TK-VV 3632 060 - (accessory, available at
additional cost)
We recommend
llow a WOLF-service centre to check the unit in the
autumn.
13