Maintaining The Appliance - Dirt Devil Renegade18 Mode D'emploi

18
Vacuuming floors
Unfasten the stop catch on the floor nozzle by pla-
1
cing your foot on the floor nozzle and tilting the ap-
pliance backwards with the handle.
appliance with the desired suction power > "Switching
the appliance on/off" on page 17.
the floor. Switch off the appliance.
4

Maintaining the appliance

Removing the rechargeable battery
Push the rechargeable battery compartment re-
1
lease catch (Fig. / ) and remove the rechargeable
1
10
battery compartment cover (Fig.
the rechargeable battery from the appliance.
Emptying the dust bin
Press the dust bin release catch (Fig.
1
move the dust bin from the appliance (Fig.
move the separator with the filter from the dust bin
(Fig. ). Dispose of the contents of the dust bin
18
3
in a waste bin. Gently tap out the dust bin to remove
any soiling.
Cleaning the separator and filter
NOTE:
The appliance and the filter should be cleaned
regularly in order to maintain the suction power.
Remove the dust bin from the appliance and the
1
separator with the filter from the dust bin > "Empty-
ing the dust bin" on page 18.
anti-clockwise to release the catch (Fig.
remove the filter cover (Fig.
tor (Fig. 20 / ). Pull on the tab to remove the pre-
3 3
motor filter from the separator (Fig.
out the separator over a waste bin. Use a dry cloth to
remove any remaining dust and dirt.
second pre-motor filter from the appliance body
(Fig. 21 ). Rinse out the pre-motor filters under run-
6
ning water (max. 40 °C). Leave the pre-motor filters to
dry for at least 24 hours.
7
filter into appliance body (Fig.
pre-motor filter into separator with tab facing up.
Place the filter cover on the separator and turn it
8
clockwise to lock it in place (Fig.
the separator with the pre-motor filter into the dust
bin (Fig. 22 ). Re-insert the dust bin into the appli-
10
ance and push it into the appliance so that you hear
and feel it click into place (Fig.
Removing and cleaning the brush roller
Switch off the appliance and set it down so that
1
the brush roller is easily accessible and the appliance
rests safely in place. Turn the roll catch anti-clock-
2
wise using a small coin (Fig.
EN
Switch on the
2
Vacuum-clean
3
/ ). Remove
1
9 2
16 ) and re-
). Re-
17
2
Turn the filter cover
2
/ ) and
19
A
/ ) from the separa-
20
1
20 / ). Tap
2 4
Remove the
5
Reinsert one pre- motor
) and the other
21
/ ). Re-insert
19
B 9
).
23
) and remove the lock-
24
ing cover (Fig. ). Raise the brush roller at the side
25
3
of the roll catch and remove it from the floor nozzle
(Fig. 26 ). Remove any dirt and hairs from the floor
4
nozzle and from the brush roller. If necessary, you can
carefully use a pair of scissors as an aid.
brush roller into the floor nozzle with the round end
first (Fig. 27 ). Fit the locking cover and turn the roll
6
catch clockwise.
Accessories
• Pre-motor filter (2x) – 0691002 (Fig.
• Power adapter DD691 – 0691003 (Fig.
• Rechargeable battery DD691-1/18V – 0691004
(Fig. 28 /C)
• Brush roller – 0691013 (Fig.
• Wall mount – 0691011 (Fig.
Troubleshooting
Before you contact our customer service department
or send the appliance to the Dirt Devil customer
service department, you will find a lot of additional
information in the service area of our website which
will help you solve problems.
www.dirtdevil.de/service
!
WARNING!
Switch off the appliance before you start trouble-
shooting. Never use a faulty appliance, charger or
rechargeable battery.
Insert the
5
/A)
28
/B)
28
/D)
28
/E)
28