Philips 3000 Serie Mode D'emploi page 10

10
English
Charging with the supply unit
2
1
Charging with charging stand (S3332, S3333 only)
Quick charge
Using the appliance
This shaver is suitable for use in the bath or
shower. For safety reasons, it is therefore not
possible to use the shaver while it is connected to
the power outlet for charging.
Note: Depending on your shaving/styling behavior and
beard type, the operating time may vary over time.
1 Put the small plug in the appliance.
2 Put the supply unit in the wall socket.
- The charging light shows the charging status of the
appliance.
3 After charging, remove the supply unit from the wall
socket and pull the small plug out of the appliance.
1 Connect the small plug of the cord into the charging
stand. Connect the supply unit into any 100V to 240V
outlet. Use only the power cord provided.
2 Place the shaver in the stand in an upright position
making sure charging contacts in the bottom of stand
fit into recess in bottom of the shaver.
- The display on the shaver will indicate the shaver is
charging.
3 After charging, remove the shaver from the stand by
lifting straight up. Do not tilt the shaver.
When you start charging the empty battery, the charging
light flashes white quickly. After approx. 5 minutes the
charging light flashes white slowly. The shaver now
contains enough energy for a 5-minute shave.
Note: This appliance is waterproof. It is suitable for use in
the bath or shower and for cleaning under the tap. For
safety reasons, this appliance can therefore only be used
without cord.