Kohler K-706075 Guide D'installation Et D'entretien page 10

7. Install the Door Assembly
Confirm the door frame is square. Adjust the frame if needed following the adjustment steps in this
manual.
On the inside of the shower, drill four 3 mm holes through the pre-drilled holes in the wall channel
using the provided 3 mm drill bit.
Install a #8 x 1/4" screw in each hole.
Repeat with the second wall jamb.
NOTE: The door may require adjustment; do not make final adjustments until the header and handle are
installed.
1280800-2-B
All manuals and user guides at all-guides.com
3 mm
10 Kohler Co.