Press
to confirm
: on
88
End of settings:
: 30
08
DISPLAY / CHANGE THE COMFORT TEMPERATURE
You can check the set Comfort temperature at any time by pressing a single time the
sion will modify the set temperature.
Note: The temperature measured by the inner sensor of the product is representative of the ambient temperature
nearby it and it may differ from the temperature measured using other instruments in other areas of the room. That
difference may depend on many factors including, for example:
- the installation position: some areas of the room may be affected by drafts or hot air sacs that modify the sensor
measurement;
- the fixation to an external wall that, being normally colder than internal walls, may imply the measurement of a tem-
perature lower than the real room temperature;
- a full load of towels on the support bar may obstruct the airflow. As a result the sensor may measure a temperature
higher than the real room temperature;
- unstable conditions: any evaluation must be done in stable working conditions. For this purpose comfort temperature
should be changed only 60min after a previous change . It is not possible, indeed, to evaluate the room temperature
maintained by the product correctly if the comfort level temperature is continually changed in a short time.
If a difference between set temperature and room temperature is detected in stable working conditions, measure the
difference and then increase or decrease the comfort temperature on the product of the exact value of measured
difference.
WEEKLY PROGRAM
The Programmed mode
desired temperature choosing between the Comfort, Eco (equal to that of Comfort decreased by 3.5 ° C) or Antifreeze.
A short press of the button
enter the view/change menu. If the product is brand new the default program is the following:
Always Frost-free mode except Comfort mode in the following hours:
- from 06:00 to 08:00 on Monday-Friday;
- from 08:00 to 10:00 on Saturday-Sunday.
Press the dedicated button to quickly activate the program mode!
To view/change the program proceed as follows:
Press and hold the
button for 3 seconds to enter the menu:
: 30
08
allows to set, for every hour of day and for every day of the week independently, the
allows to activate/deactivate the programmed functioning. A long press (> 3") allows to
22
or
key. A further pres-
3"