Radialight QUADRO Mode D'emploi page 19

Les langues disponibles

6. l

eDs color

•

There are 3 different led lights on the product:

•

Led light under the frost free button (picture 8, item H)

The led is red when the frost free mode is activated. It is switched off when the frost free mode is disabled.

Blinks when the frost free mode was activated by the open window detection function.

•

Led light under the Programmed mode button (picture 8, item I)

The led is red when the Programmed mode is activated. It is switched off when the Programmed mode is

disabled.

•

Led light under the stand-by button (picture 8, item J)

The led is red when the product is in Automatic mode or in Programmed mode and for the current day and

time the Comfort temperature has been set;

The led is green when the product is in Programmed mode and for the current day and time the Eco tem-

perature (whose value is equal to the Comfort temperature reduced by 3,5°C) has been set;

The led is switched off when the product is in Stand-by or in Programmed mode and for the current day and

time the frost free temperature has been set.

7. u

sing the Fan heater

MAIN ON/OFF SWITCH

The power supply of the product is controlled by an electromechanical ON/OFF switch. Switching off the fan heater

will cut off the power to the electronic board and this will cause the loss of every stored information, after 30 minutes

of absence of the power supply. We recommend to use this switch only when you are not using the product for long

periods and instead to use the on / stand-by control for any short-term interruptions. In this way you will not lose the

stored settings.

For the first use of the product or in case of power loss for over 30 minutes, when on ON position, the display shows

00:00 and begins counting the time starting from this value.

Should no adjustment be made within 15min after power up, the product will automatically switch in Frost

free mode with the lighting of the corresponding led.

STAND-BY BUTTON

Use this button

to switch ON or put the product in Stand-by mode. The led beneath the Stand-by button will light

on in red color.

: 00

boost