Andis Show Edge FHC Mode D'emploi page 3

SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
2
Please read the following instructions before using your new Andis clipper. Give it the care that
1
a fine precision built instrument deserves and it will give you years of service. Plug cord into
electrical outlet, operate 230/240 volt, 50 cycle AC electrical current or as noted on unit.
SPEED SELECTION
To start clipper move switch button by pressing down on the lock mechanism and moving to the
desired position (Figure A). To stop, press down on the lock mechanism and move switch button
back to original position. After using your Andis clipper, rewrap cord, and store in a safe place.
USER MAINTENANCE
Cleaning and user maintenance shall not be made by children without
supervision.
The internal mechanism of your motor clipper has been permanently lubricated by the factory.
Other than the recommended maintenance described in this manual, no other maintenance should
be performed, except by Andis Company, or an Andis Authorized Service Station.
If the supply cord is damaged it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
A
A
D
D
G
G
All manuals and user guides at all-guides.com
2
1
B
B
2
2
1
1
E
E
OIL
2
1
2
1
H
H
2
1
C
C
F
F
OIL
OIL
3