Publicité
Les langues disponibles
Les langues disponibles
V 3.03
MAINTENANCE
Before making any adjustments or changing any accessory, turn
off the tool and unplug it from its power source.
1.
Check for damaged parts. Before using any tool, any part that
appears to be damaged should be carefully checked to determine
that it would operate properly and perform its intended functions.
Check for alignment and binding of moving parts, for broken parts
or mounting fixtures, or for any other condition that may affect
proper operation. Any part that is damaged should be repaired or
replaced by a qualified technician.
2. When servicing, use only identical replacement parts. Only use
accessories intended for use with this tool. Replace damaged
parts immediately.
3. Keep the tool clean. Wipe the tool with a clean cloth and
periodically blow out all areas with compressed air. If compressed
air is not available, use a brush to remove dust from all areas.
Do not use harsh chemicals or solvents to clean the tool. These
chemicals could seriously damage the plastic housing.
4. Regularly inspect all mountings and screws to ensure tightness.
Should any screws become loose, tighten immediately.
5. If repairs are required, bring your tool to an authorized
service center.
6. Keep the vent passage clear from dirt. Clean off the accumulated
dust and oil dirt periodically.
7.
During normal operation, if anything unusual happens, the power
supply should be cut off at once and the tool should be checked
and repaired.
8. Clean the tool after each use.
REPLACING CARBON BRUSHES
CAUTION! The tool should be turned off and disconnected from the
power source before replacing the carbon brushes.
1.
Loosen the carbon brush nut with a screwdriver by turning it
counterclockwise (see Figure 3).
2. Remove the carbon brush (see Figure 4).
3. Insert the new carbon brush into the housing and replace the
carbon brush nut (see Figure 5).
4. Replace the carbon brush nut and tighten it with a screwdriver by
turning it clockwise (see Figure 6).
10
All manuals and user guides at all-guides.com
1/2 IN. DR ELECTRIC IMPACT WRENCH
For technical questions call 1-800-665-8685
8340507
Publicité
