Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Jetted Shower™ Jet Module Trim Installation
1
A.
1
2
Turn off water supplies. Unscrew test
caps (1) from the body. If this is not a thin
wall mounting, the entire plasterguard may
be removed. Remove bonnet nut (2) from
the body.
C.
6
2
5
1
A
B
B.
1
Thread sleeve (1) onto brass body,
use wrench to tighten. Place the oval
escutcheon (2) over jet body module.
Thread the jet sleeve assemblies (3) onto
the jet body module. Use the wrench (4) to
tighten the sleeve assemblies.
CAUTION: DO NOT OVERTIGHTEN.
TIGHTEN UNTIL THE ESCUTCHEON IS
FLAT AGAINST THE WALL.
Select proper label (1) (the off/on label A
is used on the standard Jetted Shower™
3
4
only) and assemble onto trim ring (2)
(Refer to chart below for proper label
selection.) Slide trim ring onto sleeve (3)
until it bottoms out on the escutcheon
(4). Install handle (5) onto stem, tighten
set screw to secure. Thread the bonnet
assemblies (6) onto the jet sleeve
assemblies (7).
7
6
Stem
Extender
C
Label
15
18T Series Installation
2
3
4
Jetted
Jetted Shower
Shower™
XO™
2 Ports
White
Blue
A
B
1
3 Ports
Black
C
Publicité
