Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Jetted Shower™ Trim Installation
2
A.
1
2
Turn off water supplies. Unscrew test
caps (1) from the body. If this is not a thin
wall mounting, the entire plasterguard may
be removed. Remove bonnet nut (2) from
the body.
C.
6
2
5
1
6
A
B
18 Series Installation - Single Unit
B.
4
1
5
3
Thread sleeve (1) onto brass body, use
wrench to tighten. Place escutcheon (2) over
jet body module. Install screws (3). Thread
the jet sleeve assemblies (4) onto the jet
body module. Use the wrench (5) to tighten
the sleeve assemblies. CAUTION: DO
NOT OVER TIGHTEN. TIGHTEN UNTIL
THE ESCUTCHEON IS FLAT AGAINST
THE WALL.
Select proper label (1) (the off/on label A
3
4
is used on the standard Jetted Shower™
only) and assemble onto trim ring (2)
(Refer to chart below for proper label
selection.) Slide trim ring onto sleeve (3)
until it bottoms out on the escutcheon
(4). Install handle (5) onto stem, tighten
set screw to secure. Thread the bonnet
assemblies (6) onto the jet sleeve
7
assemblies (7).
Stem
Extender
C
Label
11
1
Jetted
Jetted Shower
Shower™
XO™
2 Ports
3 Ports
White
Blue
Black
A
B
C
2
Publicité
