Braun CoolTec CT6cc Mode D'emploi page 14

Trouble-Shooting
Problem Possible reason
SHAVER
Unpleasant smell 1. Shaver head is cleaned with
from the shaver head.
2. Cleaning cartridge is in use
Battery performance 1. Shaver head is regularly
dropped significantly.
2. Foil and cutter are worn
Shaving performance 1. Shaving system is clogged.
dropped significantly. 2. Foil and cutter are worn.
Cooling element is 1. Shaver was used with
warm.
2. Battery capacity is too low
Shaver head is 1. Drying time after automatic
damp.
2. Drain of the Clean&Charge
CLEAN&CHARGE STATION
Cleaning does not 1. Shaver is not placed properly
start when pressing
the start button. 2. Cleaning cartridge contains
3. Appliance is in stand-by
Increased Drain of the Clean&Charge
consumption of station is clogged.
cleaning fluid.
14
All manuals and user guides at all-guides.com
water.
for more than 8 weeks.
cleaned with water but not
lubricated.
which requires more power
for each shave.
cooling function a couple of
minutes before.
for the cooling function.
cleaning was not sufficient.
station is clogged.
in the Clean&Charge station.
not enough cleaning fluid
(display lights red).
mode.
Remedy
1. When cleaning the shaver head with water only
use hot water and from time to time some liquid
soap (without abrasive substances). Remove Foil
& Cutter cassette to let it dry.
2. Change cleaning cartridge at least every
8 weeks.
1. If the shaver is regularly cleaned with water, apply
a drop of light machine oil on top of the foil once
a week for lubrication.
2. Renew Foil & Cutter cassette.
1. Soak the Foil & Cutter cassette into hot water
with a drop of dish liquid. Afterwards rinse it
properly and tap it out. Once dry apply a drop of
light machine oil on the foil.
2. Renew Foil & Cutter cassette.
1. You can use the shaver like this or turn on the
cooling function and wait a few seconds until it is
activated again.
2. Charge the shaver after each shave to ensure
sufficient battery capacity for the cooling
function.
1. Clean directly after shaving to allow enough time
for drying.
2. Clean the drain with a wooden toothpick.
1. Insert shaver into the Clean&Charge station
(contacts of the shaver need to align with
contacts in the station).
2. Insert new cleaning cartridge.
3. Press start button twice.
– Clean the drain with a wooden toothpick.
– Regularly wipe the tub clean.