Avaya 10U100 Mode D'emploi page 3

60653-01 10U100 UserGuide_r2
All manuals and user guides at all-guides.com
I M P O R TA N T S A F E T Y
I N S T R U C T I O N S
When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock, and injury to
persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product. The symbol
identifies and alerts the user to the presence of important operating and
service instructions.
3. Unplug this product from the wall outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning.
4. Do not locate base unit near water, for example, near a bath tub,
wash bowl, kitchen sink, or laundry tub, in a wet basement or near a
swimming pool.
5. Do not place this product on an unstable cart, stand or table. The product
may fall, causing serious damage to the product.
6. This product should never be placed near or over a radiator or heat
register. This product should not be placed in a built-in installation unless proper
ventilation is provided.
7. This product is intended to be used with the supplied Class 2 Direct Plug-In
Power Unit rated 9 VDC 500 mA. Plantronics Part No. 46924-01 has a rated
input voltage of 120 VAC, 60 Hz and an output voltage of 9 VDC at 500mA.
8. Do not allow anything to rest on the power cord. Do not locate this product
where the cord will be abused by persons walking on it.
9. Do not overload outlets and extension cords as this can result in the risk of
fire or electric shock.
10. Never push objects of any kind into this product through cabinet slots
as they may touch dangerous voltage points or short out parts that could result
in a risk of fire or electric shock. Never spill liquid of any kind on the product.
11. To reduce the risk of electric shock, do not disassemble this product,
but take it to qualified servicemen when service or repair work is required.
Opening or removing covers may expose you to dangerous voltages or other
risks. Incorrect reassembly can cause electric shock when the appliance is
subsequently used.
12. Avoid using a telephone equipment during an electrical storm. The
10U100 System has built-in surge protection circuits that meet or exceed FCC
requirements. However, an incident such as a lightning strike at or near the
telephone lines, could cause serious damage. There may also be a remote risk of
electric shock or damage from lightning. If the 10U100 System is installed in an
area with frequent and/or severe electrical storms, it is suggested that the tele-
phone be disconnected during these storms or that additional surge suppression
equipment be added to the installation.
13. Do not use the telephone equipment to report a gas leak in the vicinity
of the leak.
5/11/01 12:11 AM Page 2
2