GE Appliances PCB975 Manuel D'utilisation page 45

Problem Possible Causes
Range Locked
The controls have
appears in the oven
been locked.
display
Control signals after
You forgot to enter a
entering cooking time
bake temperature or
or start time
cleaning time.
Display goes blank
A fuse in your home may be
blown or the circuit
breaker tripped.
The clock is in the
black-out mode.
Display flashes
Power failure.
Unable to get the
Oven control pads were
display to show "SF"
not touched properly.
"Probe" appears in
This is reminding you to
the display
enter a probe temperature
(on some models)
after plugging in the probe.
Power outage,
Power outage or surge.
clock flashes
Steam from the vent
When using the ovens,
it is normal to see steam
coming out of the oven
vents. As the number of racks
or amount of food being
cooked increases, the amount
of visible steam will increase.
"Burning" or "oily" This is normal in a new oven • To speed the process, set a self-clean cycle for a
odor emitting from
and will disappear in time.
the vent
Strong odor
An odor from the insulation
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise
A convection fan may
automatically turn on
and off.
Oven racks are
The shiny, silver-colored
difficult to slide
racks were cleaned in a
self-clean cycle.
All manuals and user guides at all-guides.com
What To Do
• See the Control Lock section to unlock.
• Touch the BAKE pad and desired temperature or
the SELF CLEAN HI/LO pad and desired clean time.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The BROIL HI/LO and BAKE pads must be touched at
the same time and held for 3 seconds .
• Enter a probe temperature.
• Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
• This is normal.
minimum of 3 hours. See the Using the self-cleaning
oven section.
• This is temporary.
• This is normal. To maximize cooking evenness,
the fan is designed to operate in both directions,
with a pause in between.
• The convection fan will operate during preheat
of the bake cycle. The fan will turn off after the oven
is heated to the set temperature. This is normal.
• Apply a small amount of vegetable oil to a paper
towel and wipe the edges of the oven racks with
the paper towel. Do not spray with Pam
lubricant sprays.
www.GEAppliances.ca
® or other
45