GE Appliances PCB975 Manuel D'utilisation page 40

INSTALL THE RANGE
ANTI-TIP DEVICE INSTALLATION
2
An Anti-Tip bracket is supplied with instructions
for installation in a variety of locations. The
instructions include all necessary information
to complete the installation. Read the Safety
Instructions and the instructions that fit your
situation before beginning installation.
Screw must
enter wood
or metal
Typical installation of anti-tip bracket attachment to wall
WARNING —
• Range must be secured by Anti-Tip bracket
supplied.
• If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB2X7909.
• See instructions to install (supplied with
bracket).
• Unless properly installed, the range could
be tipped by stepping or sitting on the door.
Injury may result from spilled hot liquids
or from the range itself.
3 ADJUST THE REAR LEVELING LEGS
Measure the height of your countertop
A
at the rear of the opening (X).
Adjust two rear leveling legs so that the
B
rear of the cooktop is at the same height
as the counter (Y).
Slide unit into place.
C
All manuals and user guides at all-guides.com
Installation Instructions
Wall plate
Bracket
X
Y
LEVEL THE RANGE
4
A Install the oven shelves in the oven
and position the range where it will be
installed.
B Check for levelness by
placing a spirit level or
a cup, partially filled
with water, on one of
the oven shelves. If
using a spirit level, take
two readings—with the
level placed diagonally first in
one direction and then the other.
Adjust the front leveling legs from the
C
bottom.
Leg
leveler
Raise
range
Use an open-end or adjustable wrench
D
to adjust the leveling legs until the range
is level.
40
Spirit level
Lower
range