EINHELL GP-LB 36/210 Li E Mode D'emploi page 11

6.3 Turbo mode (Fig. 9)
If you need extra blowing power, for example for
clearing away wet piles of foliage, you can press
the Turbo button (5). Pressing the Turbo button
increases the speed for a short time and with it
the blowing power.
Important: Never press the Turbo button for
any longer than necessary, in order to keep
the noise level down and extend the battery
operating time.
6.4 Charging the Lithium-Ion battery
(not included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.5 Battery capacity indicator (Fig. 8)
Press the battery capacity indicator switch (13).
The battery capacity indicator (12) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depth-discharged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
Anl_GP_LB_36_210_Li_E_SPK7_USA.indb 11 Anl_GP_LB_36_210_Li_E_SPK7_USA.indb 11
EN
7. Cleaning and maintenance
HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
7.2 Maintenance
•
Should the tool experience problems
beyond those mentioned above, let only an
authorized professional or a service center
perform an inspection.
•
There are no other parts inside the equipment
which require maintenance.
8. Faults
The equipment does not work:
Check that the batteries are charged and whether
the charging unit is working. If the equipment will
not work in spite of the voltage supply being OK,
please send it to a service center.
- 11 -
18.07.2023 12:50:21 18.07.2023 12:50:21