Publicité
Les langues disponibles
Les langues disponibles
headboard bracket installation guide (optional)
Headboard Brackets are an optional accessory and are not included.
A hex key is included with the accessory kit to complete installation.
1
a.
Align the hole in the bracket to the brass sleeve into which the leg
threads. Hold the bracket in place and screw the leg into the base
until it is snug. DO NOT OVERTIGHTEN. Too much force may cause
the leg to spin freely.
b.
Align the tab with the hole in the frame (located towards the foot
of the base) and use a short bolt, washer and wingnut to secure
the bracket. Make sure the bolt is tight.
12
2
a.
Measure the distance between the mounting holes on the
headboard and install the T-Bracket to accommodate the
headboard.
b.
To install the T-Bracket, slide the T-Bracket through the end of the
headboard bracket. Align the flat side of the T-Bracket plate to the
mounting holes on the headboard.
c.
Secure T-Bracket in place by inserting two short screws through
top of bracket. Use hex key to tighten screws.
3
Connect your headboard to the attachment plate using the remaining
long screws or hardware that came with your headboard. The heads
of the bolts will face outward. Use hex key to tighten bolts.
Publicité
