Venga VG RVC 3001 BK Mode D'emploi page 11

MAXIMUM SUCTION
The robot increases its suction power
to provide a deeper cleaning process
when you press the "max" button on
the remote control. Maximum suction
is off by default. Please be aware that
this extra boost of power will consume
more energy and that the robot will
have to return to the base more often
for charging.
EDGE CLEANING
After the robot finishes cleaning the
open areas of your floor, it uses "edge
cleaning" mode to clean along walls
and around furniture legs. If you want
it to enter this mode at any point,
press the "edge cleaning" button on
the remote control.
ROOM CLEANING
When a specific room needs to be
cleaned, please press the "room
cleaning" button on the remote
control. The robot will start to zigzag to
clean the open areas, and it will finish
in edge cleaning mode to completely
clean the target room.
Note: the robot will clean and then
stop after 30 minutes in this mode.
Make sure to confine the robot to a
room by closing the door.
RETURN TO CHARGING DOCK
When at any point the robot's power
drops below 20%, it will enter auto
charge mode. This means that it will
attempt to return to its charging dock.
As the maximum signal range is 6 m,
the robot will use edge cleaning
mode to find the charging dock.
Make sure there are no obstacles
between the robot and the charging
dock.
VG RVC 3001 10