Publicité
Les langues disponibles
Les langues disponibles
Water connection
Open the tap on the water connection and draw off
approx. 10 litres of water to clean the domestic water
pipe. Then turn off the tap.
9
WARNING
Risk of electric shock
The appliance must be disconnected from the
electrical supply.
Only connect the appliance to the cold water
connection.
Fig. 10
Check that the water inlet hose is not kinked, crushed or
twisted. The plastic housing in the AquaStop contains
an electric valve so do not immerse in water. The water
inlet hose contains the connecting lines so do not cut
through this hose.
1
Screw the water inlet hose with the AquaStop to the
tap.
2
Slowly turn on the tap so it is fully open.
3
Check the connections and water inlet hose for
leaks.
16
Installing the appliance
1
Securely insert the front line into the appliance
(snaps into place). For this purpose, put the
appliance to be plugged in just on to the edge of
the unit. Plug the power cord into the socket.
Fig. 12
Plug transformer into dedicated receptacle in an
accessible cabinet adjacent to the coffee maker
(depends on the built-in situation). Do not plug into
a receptacle behind the appliance. Push the
appliance into the unit until it clicks into place.
Important:
The socket must be freely accessible
after the appliance has been installed.
2
Check the water drainage. To do so, slowly pour
approx. 0.5 l water from a container, e.g. jug, into
the drip tray. The water must drain off completely.
Fig. 13
If the water fails to drain off, check installation of
the hose and the waste water connection according
to the information in these installation instructions.
3
Check that the appliance is in the middle. If
necessary, align the appliance. To do so, pull the
appliance out a little, remove the appropriate
spacers
(e)
and attach to the left side (top and
bottom). Push the appliance into the unit until it
clicks into place. Adjust the appliance so it is
aligned horizontally and vertically. The appliance
should not stand at an angle of more than 1° (2%)
in any direction!
Fig. 14
4
Take hold of the appliance door on the right next to
the outlet and open. Remove the drip tray
the cover
on the bottom left-hand side forwards
(X)
and remove. Pull out the accessories drawer
and put to one side.
5
First, screw on the appliance as shown using 2 of
each of the fastening screws
sleeves
(j)
. Then screw tight at the top right of the
unit using 1 fastening screw
Fig. 16
Then:
‒ Open the door at an angle of approx. 55°.
‒ Screw in the screws
‒ Fit the hinge dampers
6
Only for the qualified installer:
In very few cases, the door of the built-in fully
automatic coffee machine can jam due to a
misalignment in the cabinet where the unit is built
in. The door can be adjusted. To do this adjust the
hinges at the top and the bottom:
‒ Adjust the depth of the door by turning the
screws
.
(V)
Fig. 17.I
‒ Remove the hinge dampers at the top and
bottom of the hinges. Turn the screws
adjust the inclination and the horizontal position
of the doors.
‒ Re-fit the hinge dampers.
(Y)
Fig. 15
(f)
and
(g)
as well as 2
and sleeve
(f)
(h)
.
(n)
.
(o)
(W)
Fig. 17.III
. Pull
(Z)
.
to
Publicité
