Husqvarna 330iKP Manuel D'utilisation page 27

Two piece-shaft
Apply grease to the end of the drive shaft after
each 30 hours of operation. There is a risk
that the drive shaft ends (splined coupling) on
models with two-piece shafts will seize if they
are not lubricated regularly.
Keypad
Power button LED flashes
Continuous
2 flashes
3 flashes
4 flashes
5 flashes
6 flashes
9 flashes
10 flashes
2113 - 004 - 03.11.2023
Troubleshooting
Possible faults
Low battery power.
Undervoltage.
Bad battery.
Overcurrent.
High temperature.
Rotation block fault.
Protection mode activated. 1. Turn off the product.
Battery communication er-
ror.
Possible action
Charge the battery.
1. Turn off the product.
2. Turn on the product again.
3. If the problem continues, speak to
your servicing agent.
Replace the battery.
1. Turn off the product.
2. Turn on the product again.
3. If the problem continues, speak to
your servicing agent.
Let the product cool down.
1. Turn off the product.
2. Turn on the product again.
3. If the problem continues, speak to
your servicing agent.
2. Turn on the product again.
3. Change your work method if the
protection mode turns on again.
1. Remove the battery.
2. Clean the battery connectors with
compressed air or a soft brush.
3. Install the battery again correctly.
27