Proceed with cleaning and/or maintenance operations. Hold
5
the blades in the centre to avoid being cut. It is very important
to remove the embedded material at the bottom of the blades.
The accumulation of raw material debris in this area drastically
reduces the cutting efficiency of the blades.
To reassemble the MT Gentle 50 and/or 75, position the blades as
7
shown in the following image. Fix them with the screws previously
removed and with the help of the Allen key Nº 4.
Replace the container and secure it with the help of the two retaining knobs (G). Lastly, connect the container motor cable to the power input
9
located on the side of the machine body.
Thoroughly clean the grid by spraying with water, preferably hot,
6
or Master Clean liquid. Take advantage of the condition of the
machine to clean the interior area.
Replace the grid back on top and fasten it with the four latches.
8
www.masterproducts.es
31