Inventum RVW6027AB Mode D'emploi page 40

WHAT TO DO IF...
...the program won't start?
• Check if the plug is connected.
• Check the fuse in the fuse box.
• Make sure the water tap is open.
• Make sure the door of the dishwasher is closed properly.
• Check whether the dishwasher is turned on with the On/off button.
• Check whether the water inlet hose and filters aren't clogged.
...the indicator lights won't go off after the cycle has finished?
• The On/ off button is not released yet.
...detergent residues are left in the detergent reservoir?
• Detergent has been added when the reservoir was damp.
...water is left inside the dishwasher at the end of the cycle?
• The water drain hose is clogged or twisted.
• The filters are clogged.
• The cycle has not finished yet.
...the dishwasher stops during a wash cycle?
• Power failure.
• Water supply failure.
• The program can be paused.
...you hear noise during a wash cycle?
• The dishwasher is not loaded properly.
• One of the spray arms is hitting the dishes.
...there are partial food wastes left on the dishes?
• The dishes aren't placed correctly which prevents the spray arms from reaching everything.
• The basket is overly loaded.
• The dishes lean against each other.
• Too small amount of detergent is added.
• Wrong program selected.
• One of the spray arms is clogged with food waste.
• The filters are clogged.
• The filters are not placed correctly.
• The water drain pump is clogged.
...there are whitish stains on the dishes?
• Too small amount of detergent is added.
• The dosage of the rinse aid is too low.
• In spite of the high level of water hardness there is no special salt added.
• The level of water hardness is set too low.
• The cap of the salt reservoir is not closed well.
...the dishes won't dry?
• A program without a dry process was selected.
• The dosage of the rinse aid is too low.
• The dishes are unloaded too fast.
...there are rust stains on the dishes?
• The stainless steel quality of the dishes is insufficient.
• The dosage of salt is too high.
• The cap of the salt reservoir is not closed well.
• Too much salt was spilt inside the dishwasher while refilling the reservoir.
• The water mains is polluted.
Contact the service department of Inventum when a malfunction occurs which is not described.
40
• English