To Do Before You Operate The Product; Safety Instructions For Maintenance; Operation - Husqvarna DM 200 Manuel D'utilisation

WARNING: The PRCD must be examined
each time the power plug is connected to a
power outlet.
WARNING: If the PRCD must be repaired,
always speak to an approved HUSQVARNA
service agent.
1. Connect the power plug of the product to a power
outlet.
2. Push the "RESET" button. The indicator above the
button is red when the current is connected.
3. Start the product, refer to
page 11 .
4. Push the "TEST" button. If the product stops, the
PRCD operates correctly. (Fig. 8)
Isolation transformer
Note: Applicable for 110V type sold in United Kingdom
and Ireland.
Do not operate the 110V type of the product without
isolation transformer that refers to EN/IEC 61558-1 and
EN/IEC 61558-2-23.
The isolation transformer must have ground wires on the
230V and the 110V side.
Power switch
The power switch is used to start and stop the product.
(Fig. 9)
To examine the power switch
1. Connect the power plug of the product to a power
outlet.
2. Push the power switch to start the product. (Fig. 10)

To do before you operate the product

1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do the daily maintenance. Refer to
schedule on page 12 .
3. Make sure that the nominal voltage and current in
the power outlet is the same as the voltage and
current of the product.
4. Make sure that the PRCD is started. Refer to
on page 9 and To examine the PRCD on page 9 .
5. Make sure that the work area is clean and bright.
6. Use personal protective equipment. Refer to
Personal protective equipment on page 9 .
10
To start the product on

Operation

Maintenance
PRCD
3. Release the power switch to stop the product. (Fig.
11)
Friction clutch
The friction clutch is integrated in the gearbox of the
product. It prevents damage to the product if the drill bit
stops during operation. If the load is too high, the friction
clutch is released and stops the drill spindle but keeps
the motor on for some seconds. The friction clutch
engages again if the load is decreased and the
operation can continue. If the drill bit is caught in the
material and fully stops, the friction clutch stops the
motor immediately.
CAUTION: Make sure that the release time
of the clutch is not more than 3-4 seconds,
because if not wear and heat will increase
quickly.

Safety instructions for maintenance

WARNING: Inspection and/or maintenance
should be carried out with the motor
switched off and the plug disconnected.
• Maintain power tools and accessories. Check for
misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the
power tool's operation. If damaged, have the power
tool repaired before use. Many accidents are caused
by poorly maintained power tools.
• Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
• Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
7. Make sure that the product is installed correctly. The
drill bit must be attached correctly.
8. The auxiliary handle must be connected and fully
To use the auxiliary handle on
tightened. Refer to
page 11 .
9. When you operate the product dry, use a dust
To prepare the product for dry
extractor. Refer to
drilling on page 11 .
10. When you operate the product wet, make sure that
the water system is not damaged and use the water
To prepare the product for wet
connector. Refer to
drilling on page 11 .
1416 - 006 - 29.01.2021