Leggett & Platt Simplicity HFM Guide De Configuration page 3

7
Rotate base over onto its legs.
Remove remaining packaging.
10 Operate remote control to test base
functions. See Remote Control User
Guide for programming instructions.
Your base may be equipped with a Micro-Hook™ system to hold the mattress in
OPTIONAL
place, but a wire mattress retainer can still be used. Insert the mattress retainer
into the holes at the foot end of the base.
IF ADJUSTABLE BASE WILL NOT OPERATE, REFER TO THE TROUBLESHOOTING
SECTION OF THE REMOTE CONTROL USER GUIDE.
TEAM
LIFT
MICRO-HOOK™
STRIPS
NOTE
CUSTOMER SERVICE toll free: (800) 888-3078
Install batteries in
8
remote control.
11 Lower base to flat position.
9
Plug power cord into power outlet.
NOTE
AN ELECTRICAL SURGE
PROTECTION DEVICE IS
RECOMMENDED (NOT INCLUDED).
3