Generac 000393a Manuel Du Propriétaire page 8

General Information and Setup
4. See Figure 2-13. Connect high-pressure
hose to pump and hand-tighten.
Figure 2-13. Connect High-Pressure Hose
to Pump
5. See Figure 2-14. Connect high-pressure
hose to base of spray gun and hand-
tighten.
Figure 2-14. Connect High-Pressure Hose
to Spray Gun
Spray Gun
Become familiar with spray gun trigger and
locking system prior to use.
1. See Figure 2-15. With unit OFF, hold spray
gun and squeeze trigger to learn how
trigger mechanism and locking system can
be activated and deactivated.
Figure 2-15. Spray Gun (typical)
2. Turn ON the water, and squeeze the
trigger to purge the pump system of air.
6
Nozzles
1. Select correct nozzle for task.
2. See
012434
3. Release quick-connect collar to secure
4. Verify nozzle is locked in place.
Blast Pressure Nozzle (Red)
MAXIMUM - Higher pressure and lower flow
for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil
stains, rust removal
substances (tar, gum, grease, wax, etc.).
000122
Clean Pressure Nozzle (Green)
GENERAL - Medium pressure and medium
flow for most all purpose cleaning such as
home siding, brick patios, wood decks,
driveways and sidewalks, garage floors, etc.
Wash Pressure Nozzle (White)
DELICATE - Lower pressure and higher flow
for gentle cleaning of cars/trucks, boats, RV's,
patio furniture, lawn equipment, etc.
000123
2-16. Pull back quick–connect
Figure
collar and install nozzle.
Figure 2-16. Insert Nozzle
nozzle.
Owner's Manual for Power Washer
000125
or other stubborn
001396
001398
001399