Maintaining the Battery
See
Figure
4-12. Check the charge of the
battery by pressing the Battery Powerbar™
button. A minimum of 2 illuminated LED lights
are required to start the engine.
Figure 4-12. Battery Powerbar™ Button
Charge the Battery
NOTE: The 12V Lithium-ion battery provided
should be used only with the battery charger
supplied with
the power washer (P/N:
10000020284).
1. See
4-13. Remove battery from
Figure
box.
Figure 4-13. Remove Battery
2. Plug battery charger into a 120V, 60Hz,
AC receptacle only. The green "READY"
LED on the charger will illuminate.
3. Slide battery into charger bay. The red
"CHARGING"
LED
indicate charging.
4. When battery is fully charged, the green
"READY" LED will illuminate. Remove
battery from charger.
NOTE: A completely discharged battery will
fully charge in approximately 1.5 hours. The
battery will stay fully charged if left on the
charger with no damage to the battery. The
battery needs to be replaced if the green
"READY" LED does not illuminate after 3
hours of charging. See
5. Return battery to box and close the lid for
use.
6. Unplug battery charger from receptacle
when not in use.
Owner's Manual for Power Washer
006467
012430
will
illuminate
Replace the
Battery.
Replace the Battery
Explosion. Do not dispose of batteries in a fire.
Batteries are explosive. Electrolyte solution can cause
burns and blindness. If electrolyte contacts skin or eyes,
flush with water and seek immediate medical attention.
Risk of burn. Do not open or mutilate batteries.
Batteries contain electrolyte solution which can cause
burns and blindness. If electrolyte contacts skin or
eyes, flush with water and seek immediate medical
attention.
Environmental Hazard. Always recycle batteries at an
official recycling center in accordance with all local
laws and regulations. Failure to do so could result in
environmental damage, death, or serious injury.
Contact your nearest Independent Authorized
Service Dealer (IASD), or contact Generac
Customer Service at 1-888-GENERAC (1-
888-436-3722), for battery replacement.
Storage
General
Explosion and Fire. Fuel and vapors are extremely
flammable and explosive. Add fuel in a well
ventilated area. Keep fire and spark away. Failure
to do so will result in death or serious injury.
Risk of Fire. Verify machine has properly
cooled before installing cover and storing
machine. Hot surfaces could result in fire.
• DO NOT place a storage cover on a hot
to
power washer. Allow unit to cool to room
temperature before storage.
• DO NOT store fuel from one season to
another unless properly treated.
• Replace fuel container if rust is present.
Rust in fuel will cause fuel system
problems.
• Cover unit with a suitable protective,
moisture resistant cover.
• Store unit in a clean and dry area.
• Always store power washers and fuel away
from heat and ignition sources.
Maintenance and Troubleshooting
WARNING
WARNING
WARNING
DANGER
WARNING
(000162)
(000163a)
(000228)
(000105)
(000109)
17