Publicité
Les langues disponibles
Les langues disponibles
20. When heating up and cooling down the heater, you may hear a ticking sound. This
is normal.
21. There may be a paint smell when using your heater for the first time. This will
disappear after several hours of using the heater.
22. Do not store away the heater until the heater is cool down. Store the heater in a
cool dry location when not in use.
23. When in use, keep the distance between window(wall) at least 50cm.
2. The device
1. Place the radiator body upside-down on a scratch-free location, make sure it is
stable and will not fall.
2. Screw off the wing nuts from the U-shaped bolt provided, attach the U-shaped
bolt to the U-facing flange between first and second fins (near the front cover).
3. To attach the castor mounting plate to the radiator body, you should insert the
threaded ends of the U bolt in the holes on the castor mounting plate.
4. Screw the wing nuts back to the U bolt and fasten the wing nut properly.
Note: do not over tighten, which may cause the damage of radiator flange.
5. Screw off spherical nut from the castor, align the shaft to the hole of the castor
mounting plate, insert in and screw on the spherical nut.
6. Repeat 2, 3, 4 and 5 on the rear of the radiator for mounting of the rear castors.
Note: the rear castors must be fastened between the end two fins.
1. Indicator light
2. Setting knob
3. Thermostat knob
4. Radiant fins
5. Cord storage
6. Castor
19
Publicité
