Publicité
Les langues disponibles
Les langues disponibles
CONNECTING
AN OUTDOOR ANTENNA
BEFORE OPERATION
For better
FM reception,
use of an outdoor
antenna
recommended.
Connect the outdoor antenna to the FM 75 Q terminals.
1
is
To connect other optional equipment+
page 22.
REMOTE CONTROL
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
R6(AA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (television, etc.)
_—.
—-/
l?–-+--–-
–+-
ET=i+-
=4=+
I
II
J
.
I
Jq
L_____
———--~.
p_
——
_—
To turn the unit on
CD
Press one of the function buttons (TAPE, TUNER, VIDEO/AUX,
CD).
Playback of the inserted disc or tape begins, or the previously
tuned station is received (Direct Play Function).
The POWER button is also available.
The disc compartment may open and close to reset the unit.
DEMO (Demonstration)
mode
When the AC cord is connected for the first time, the display
window demonstrates the functions of the unit. When the power
is turned on, the DEMO display is overridden by the operation
display.
When the power is turned off, the DEMO mode is
restored.
To cancel DEMO mode
Press the DEMO button. To reenter, press again.
Illumination
guides
Whenever the AC cord is connected or one of the function buttons
is pressed, the buttons for that operation light up or flash.
Example: When the AC cord is connected, the II SET button
flashes as a guide to setting the current time,
Flash windows
The windows on the top of the unit and the cassette decks light
up or flash while the unit is being powered on.
To turn off the light of the top window, press the
button while
pressing the CD button. To turn back on, repeat the above.
To turn off the light of the cassette decks, press the
button
while pressing the TAPE button.
To turn back on, repeat the
above.
After use
Press the POWER button to turn off the power. The display
changes to the clock.
5
ENGLISH
Publicité
