Publicité
Les langues disponibles
Les langues disponibles
SETTING THE TIMER
1
2,4
3
1,2
6
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly. (See page 6.)
1 Press the TIMER button on the remote control
once to display 0, and press the II SET button
within 4 seconds.
@ is
displayed, and the hour flashes.
@
m
If you do not press the 11SET button within 4 seconds, another
operation may start.
2 Designate
the hour
of the timer-on
time
by
pressing the l<<
DOWN or
WI
UP button, and
the II SET button. Repeat to designate the minute
of the timer-on time.
After vou designate the timer-on time, TIMER and one of the
source name flashes alternately on the display for 4 seconds.
3 Within
4 seconds,
press
one of the function
buttons to select a source.
"TIMER and the selected source name flash alternately for 4
seconds. At this time, the selected function button does not
light up,
If this step is not completed within 4 seconds, repeat from
step 1.
. If the TUNER button is pressed, the band cannot be selected
in this step.
4 Within
4 seconds,
select
the duration
for the
timer-activated
period with the
l<<
DOWN or F>l
UP button.
5
6
The duration for the timer-activated period can be set between
10 and 240 minutes in 10-minute steps.
If this step is not completed within 4 seconds, repeat from
step 1,
Prepare the source.
To listen to a CD, load the disc to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
Press the POWER button to turn the unit off after
adjusting the vollume i~rtd tone.
O
remains on the display alter the power is turned off (timer
standby mode).
When the timer-on time is reached, the unit
begins play with the selected source.
To check the specified time and source
Press the TIMER button on the remote control.
turns on and
The timer-on
time and the selected source name are displayed for 4 seconds.
However, the duration for the timer-activated period will not be
displayed.
TIMER RECORDING
Timer recording is applicable fc)rTUNER and VI DEO/AUX (with
an external timer) sources cmly.
Press the TIMER button twice on the remote control so that
Q appears on the display, and press the 11SET button within
4 seconds.
Repeat the steps shown above from step 2 and
insert the tape to be recorded into deck 2 after step 5.
To cancel timer standby mc)de temporarily
Press the TIMER button on the remote control so that @ or Q
disappears on the display.
To restore the timer standby mode, press again to display@ or
g.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume and tone.
m
Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
21
ENGLISH
Publicité
