Publicité
Les langues disponibles
Les langues disponibles
LISTENING TO EXTERNAL
SOURCES
1
J____
.__
——
---
,— —_,_
—_.—-
To play equipment connected to the VIDEO/AUX jacks, proceed
as follows.
1
Press the VIDEO/AUX
button.
VIDEO appears on the display.
2 Play the connected
equipment.
To change a source name
in the display
When the VIDEO/AUX button is pressed, VIDEO is displayed
initially. It can be changed to AUX or TV.
With the power on, press the POWER button while pressing the
VIDEO/AUX button.
Repeat the procedure to select one of the names.
To adjust the sound level of the external source
When the sound level of the external source is much higher or
much lower than that of other function sources, adjust it as
follows.
1
Press the VIDEO/AUX button and play the equipment.
2 Turn the VI DEO/AUX INPUT LEVEL control on the rear panel
until the sound level becomes the same as that of other
function sources.
23
ENGLISH
CARE AND MAINTENANCE
Occasional care and maintenance of the unit and the software
are needed to optimize the performance of your unit.
To
clean the cabinet
Use a soft and dry cloth.
If the surfaces are extremely
dirty, use a soft cloth lightly
moistened with mild detergent
solution.
Do not use strong
solvents, such as alcohol, ~enzine or thinner as these coul~
damage the finish of the unit.
To clean the heads and tape paths
After every 10 hours of use, clean the heads and tape paths
with a head cleaning cassette or cotton swab moistened with
cleaning fluid or denatured alcohol. (These cleaning kits are
commercially available.)
When cleaning with a cotton swab, wipe the recording/playback
head, erasure-head (deck 2 only), capstans, and pinchrollers.
/'
--l
I
Playbackhead Cottonswab
I
c
(
I
Pinch roller
Erasurehead
Pin)hroller
I
\
!
f
\
After cleaning the heads and tape paths with a liquid head
cleaning cassette or a moistened swab, wait until the cleaned
parts are completely dry before inserting the tapes.
To demagnetize
the heads
The heads may become magnetized after long-term use. This
may narrow the output range of recorded tapes and increase
noise. After 20 to 30 hours use, demagnetize the heads with
any commercially available, demagnetizer.
Care of discs
When a disc becomes dirty, wipe the disc from the center out
with a cleaning cloth.
After playing a disc, store the disc in its case. Do not leave the
disc in places that are hot or humid.
Care of tapes
Store tapes in their cases after use.
Do not leave tapes near magnets, motors, television sets, or
any source of magnetism.
This will downgrade the sound
quality and cause noise.
Do not expose tapes to direct sunlight, or leave them in a car
parked in direct sunlight.
Publicité
