Publicité
Les langues disponibles
Les langues disponibles
3. Wind speed button
Press the button "SPEED" to switch the wind speed between low and high. The corresponding indicator
light "LOW"/"HIGH" will illuminate.
4. Mode button
Press the button "MODE" to choose your desired working mode among cooling, dehumidification and fan.
-
Under cooling mode, the corresponding indicator light "COOL" will illuminate. Press the button
"TEMP+"/"TEMP-" to set your desired room temperature. Press the button "SPEED" to set your desired
wind speed.
-
Under dehumidification mode, the corresponding indicator light "DEHUM" will illuminate. The
appliance will automatically set the working temperature (2℃ below the current room temperature)
and set the wind speed at low. Temperature and wind speed cannot be adjusted manually.
-
Under fan mode, the corresponding indicator light "FAN" will illuminate. Press the button "SPEED" to
switch the wind speed between low and high. Please note: Under this mode, no temperature function
is equipped. The digital display shows a value and that is meaningless.
5. Timer on/off button
Timer ON setting:
When the appliance is OFF, press the button "TIMER", the corresponding indicator light "TIMER" will
-
illuminate.
Press the button "TEMP+"/"TEMP-" to select a desired ON time from 1-24 hours. The "Preset ON Time"
-
will flash on the digital display. Press the button "TIMER" again (when still flashing) and the setting will
be in effect.
The appliance will automatically turn on once the "Preset ON Time" has passed.
-
Timer OFF setting:
When the appliance is ON, press the button "TIMER", the corresponding indicator light "TIMER" will
-
illuminate.
Press the button "TEMP+"/"TEMP-" to select a desired OFF time from 1-24 hours. The "Preset OFF
-
Time" will flash on the digital display. Press the button "TIMER" again (when still flashing) and the
setting will be in effect.
The appliance will automatically turn off once the "Preset OFF Time" has passed.
-
Note: The digital display will show the countdown time by hour after the timer is set. Press the button "TIMER"
again, the timer function will be canceled.
CAUTIONS for cooling and dehumidification operations:
When using functions on cooling and dehumidification, keep an interval of at least 3 minutes between
-
each power on or off.
Power supply shall meet the requirements.
-
The socket is suitable for AC use.
-
Do not share one socket with other appliances.
-
Power supply is AC220-240V, 50Hz.
-
Water full alarm
Under normal use, the unit can evaporate the condensed water automatically, and little of water will be
accumulated in the inner water tray.
As soon as the condensed water collected in the inner water tray reaches a certain height, a water full alarm
will be sent out: the water full indicator light will illuminate, and the digital display will show "E2" code approx.
5 minutes later.
Thus, when the water full alarm occurs, please drain the water in the water tray. Remove the rubber stopper
from the drain port at the bottom of the unit, and drain out the water.
- 6 -
Publicité
