Publicité
Les langues disponibles
Les langues disponibles
EN
Flame Color Setting:
The initial flame color is orange. Press the "COLOR MODE"
button on the remote control, the display window will
change from the temperature interface to the flame color
setting interface.
Each time you press, the flame color will change to: C-1
Orange; C-2 Green; C-3 Blue; C-4 White; C-5 Green +
Orange; C-6 Orange + Blue; C-7 Orange + White; C-8
Green + Blue; C-9 Green + White.
Child Lock Setting:
The remote control and touch panel both have child lock function.
After finished all functions settings, press the "UP" and "Down"
button together for 3 seconds, or press " child lock" button on
the remote control, you will hear the short buzzer sound, then
the fireplace is in locked function, and all the buttons can not be
operated. In the middle of the display window is in a flickering
LOCK
state and shows "L". After 10 seconds, the display window will be
back to the room temperature display. If you want to operate the
touch panel and the remote control again, you need to press the
"UP" and "DOWN" button together on the touch panel for 3
seconds or "child lock" button on the remote control for one
second, and you will hear the short buzzer sound, then the child
lock function is unlocked.
13. Room temperature display error correction function:
When in use the heater, if the heater displays the room temperature with
the actual room temperature have error, you can use the temperature
display error correction function to change the display window room
temperature, through long time press TIME key on the touch panel by 3
seconds, then the display window of room temperature normally light
change to temperature correction display, the digital display is in the
flashing display mode. When the first time used the temperature error
correction function, press the TIME button for 3 seconds, and the display
window will be displayed as 0. At this time, every time you press the up or
down key of the remote control, the display window will be up +1 or down
-1 accordingly, and the correction range is between -9 and 9. If on the
temperature error correction mode, 10S no operation of the touch panel or
remote control, then the display window will be turned back to the room
temperature display mode.
16
14. Screen protection function:
The heater has a screen protection function. If the heater after working
without operation on the touch panel or remote control after 30 seconds,
all lights on the touch panel will be turned off expect the power on light.
The heater on normal work, if you need to wake up the display again,
then you only press any button on the touch panel or on the remote
control then it can be shown again.
15. NTC Error Alarm Function:
The temperature can be adjusted when NTC plugged in. Unplug the NTC,
the display window will display "E-1", and the temperature touch button
cannot be operated.
When the heater is turned on for the first time, there may
NOTICE
be a slight smell, which is normal. It will not happen again
unless the heater is not used for a long time.
To improve operation, aim the remote control at the front
NOTICE
of the fireplace. DO NOT press the buttons too quickly.
Give the unit time to respond to each command.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the
heater reach an unsafe temperature, the heater will automatically turn
OFF. To reset:
1. Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes.
2. Unplug the power cord from the outlet.
3. Inspect the fireplace to make sure that no vents are blocked, or clogged
with dust or lint. If they are, use a vacuum cleaner to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back
into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a
professional.
EN
17
Publicité
