Publicité
Les langues disponibles
Les langues disponibles
EN
Risk of electric shock! DO NOT OPEN! No user-serviceable
●
parts inside!
ALWAYS turn this heater off before unplugging it from the
●
outlet.
ALWAYS disconnect this unit from the power supply before
●
performing any assembly or cleaning, or before relocating the
electric fireplace.
NEVER leave this heater unattended. ALWAYS unplug this
●
heater when not in use.
ALWAYS store this heater in a dry location. NEVER use the
●
fireplace if it has become wet.
NEVER plug this heater into an outlet that is old, cracked, or
●
has any loose wires or connections. Plugging this heater into a
faulty outlet could result in electric arcing within the outlet
that could cause the outlet to overheat or catch fire.
ALWAYS check your heater cord and plug connections with
●
each use!
i)MAKE SURE the plug fits tight in the outlet! Faulty wall outlet
connections or loose plugs can cause the outlet to overheat.
ii)Heaters draw more current than small appliances.
Overheating may occur even if it has not occurred with the
use of other appliances.
iii)During use, check frequently to see if the plug outlet or face
plate is HOT!
iv) If the outlet or face plate is HOT, discontinue use
immediately and have a qualified electrician inspect and/or
replace the faulty outlets.
The power cord supplied with
●
the heater has a plug with two
flat blades (live and neutral) and
one round pin (ground). If a
3-slot receptacle is not available,
an adapter MUST be used. The
adapter MUST be properly
grounded to the outlet box (see
figure at right). (Note: Adapter
NOT INCLUDED.)
SAVE THESE INSTRUCTIONS!
●
04
Grounding Pin
Adapter
PREPARATION
This product includes a GLASS panel! Always use
extreme caution when handing glass. Failure to do so
could result in personal injury or property damage.
Remove all parts and hardware from the carton and place them on a
clean, soft, dry surface. Parts and assembly steps are grounded for
wall-hanging or recessing use. Check the parts list to make sure
nothing is missing. Dispose of packaging materials properly. Please
recycle whenever possible. You will need the following tools (not
included): Phillips screwdriver; stud finder; level; tape measure;
electric drill; 1/4" wood drill bit, hammer.
Grounding instructions:
This heater is for use on 120 volts. The cord has a plug as
shown at A in Figure 60.1. An adapter as shown at B is
available for connecting three-blade grounding-type plugs to
two-slot receptacles.
The green grounding lug extending from the adapter must be
connected to a permanent ground such as a properly
grounded outlet box. The adapter should not be used if a
three-slot grounded receptacle is available.
Figure 60.1
Grounding methods
GROUNDING PIN
(A)
NOTE: Adaptors are NOT for use in Canada
EN
METAL SCREW
COVER OF GROUNDED
OUTLET
BOX
(B)
05
Publicité
