Publicité
Les langues disponibles
Les langues disponibles
EN
High Temperature & Low Temperature Setting
Press "HEAT" button for 3 seconds to switch the
temperature between °F and °C ( Note: The switch
function is not available for different batches of fireplaces.)
The initial default temperature is 72°F(22°C). If you need
the fireplace runs the low temperature heating mode,
press the HEAT button on the touch panel or remote
HEAT
control to switch your desired mode (Low temperature
mode). (Press the button for the 1st time, the display
window shows that the current heating mode, such as the
default mode is high temperature heating, that is, "HH".
Press the button again, the display shows "LL", that is low
temperature heating mode. Press the button for the 3rd
time, it displays "OO", that is, the heating mode becomes
OFF mode. The heating mode will be work on "HH-LL-OO"
three modes in cycles. ) If you need to turn off the heating
setting, you can also press the "DOWN" button. If the
setting temperature is lower than room temperature, the
heating function cannot be activated. When the heating is
turned off, the fan inside the electric fireplace will work
last for 10 seconds before totally stopped.
Timer Setting:
Timer can be set between 0-12 hours. The default timer is
0 hour. You can set it according needs with "TIMER" on the
touch panel or remote control. Press "TIMER" button when
the display window shows "00" and flashes, then the timer
TIMER
will change ( From 0.5H-1.0H-1.5H-2H-...-11H-11.5H-12H)
when you press. After setting to the required timer, the
indicator light will flash for 10 seconds, then the setting is
successful. Then the display window could back to show
the room temperature.
14
Temperature Increasing Button:
The temperature can be set from 60°F (15°C)to 97°F
(36°C). The default temperature is 72°F (22°C). Press the
"UP" button on the touch panel or remote control each
time, the temperature will add 1°F/1°C. Press the "UP"
button for a long time, the number of temperature will
continually increase until maximum temperature.
After 10 seconds no operation on temperature setting, the
display window will back to the room temperature.
Temperature Decreasing Button:
The temperature can be set from 60°F (15°C)to
97°F(36°C). The default temperature is 72°F (22°C). Press
the "DOWN" button on the touch panel or remote control
each time, the temperature will decrease 1°F/1℃. Press
the "DOWN " button for a long time, the number of
temperature will continually decrease until minimum
temperature (Long-time pressing is not suitable on the
remote control). The red light flashes when setting. After
10 seconds no operation on temperature setting, the
display window will back to the room temperature.
Flame Brightness Setting:
The flame brightness is on the brightest mode by default.
There are 5 flame brightness levels. If you need to adjust
the flame brightness, press the "DIMMER" button, the
brightness of the LED lamp will become dark, and the
display window of digital tube will show the level of the
FLAME
brightness. (In the middle of the digital tube will show the
brightness level (5-4-3-2-1)). Every time pressing the
DIMMER button, the number will minus 1, when the flame
is in the darkest, then you press the "DIMMER" button, it
will be back to the brightest flame again.
EN
15
Publicité
