Publicité
Les langues disponibles
Les langues disponibles
EN
RECESSED TO WALL INSTALLATION
WARNING
Only qualified person can perform the installation.
W
hole size
H
( A )
Framing Hole Size
Model Number
FP10131US-DK
47.5"(120.6cm)
Wall Anchors
(4pcs)
W
H
( B )
08
STEP A. Select a dry
wall to open a hole
for fireplace box.
Size of hole as
below chart.
W
H
19"(48.3cm)
STEP B. Punch 4 holes around
the wall and install 4 Drywall
anchors (Part C), please drive
C completely into the wall.
Showed on the drawing.
Figure (B)
（C）
The fourth screw
from top to bottom
STEP C. Take off the screws (The fourth screw from top to bottom) in
both sides of fireplace. Figure (C)
STEP D. Remove packaging attachments from the log set.
1.Remove the front grass.
2.Remove the pearl cotton block.
3.Remove the log set's packaging bag.
STEP E. Have two persons to take the glass panel out of the
fireplace box. Place it to a soft and clean place. Figure (E)
W
hole size
H
（F）
（G）
STEP F. Take off the two screws in both sides of fireplace. Figure (C)
If the appliance is fully recessed into the wall:
Use the 4 screws(provided) to lock the appliance into wall with the
existing two side flanges, see Figure(F)
Install the media and re-install the glass front.
STEP G. Place the front panel to fix the appliance. See Figure (G)
STEP H. Fireplace will be like this after installation. Figure (H)
EN
（E）
（H）
09
Publicité
