Panasonic CZ-RTC2 Manuel D'instructions page 9

3. Setting the Present Time
1. Press and hold
present day and time setting mode.
Once you enter the setting mode,
"time" fl ash.
2. Set " " to today's day of the week.
Press
display) in the order of : Su → Mo → Tu → .... Press
to move it in the order of : Su → St → Fr → ....
*1
While in time setting mode, the Temperature setting
buttons function as
3. Press
Set the present hour and press
The "hour" digits light up, and the "minute" digits start fl ashing.
*2
If the clock uses the 12 hours AM/PM setting, the hour is displayed in the
range of AM 0 to 11/PM 0 to 11.
4. Press
Set the present minute and press
fi nishes the setting mode.
Note
• The unit returns to the normal mode if
during the setting. In this case, all the settings in progress will be lost.
• If the present time is invalid, "– – : – –" is displayed.
If the power failure for more than 1 hour occurs, check if the set data of day and time are valid.
n.indb EN-5 n.indb EN-5
for more than 2 seconds to enter the
1
* to move " " (fl ashing on the
(changing day) button.
to change the present "hour" in the range of 0 to 23 *
/
/ to change the present "minute" in the range of 0 to 59.
, " "(day) and
.
. The day and time are set and the unit
is pressed or there is no operation made for 3 minutes
EN-5
3,4 1,3,4
2
.
2
EN
2011/ 2011/