Panasonic CZ-RTC2 Manuel D'instructions page 16

5. Outing Function (Continued)
• Setting the Outing Function
1. Press and hold
the upper limit temperature setting screen.
, and the upper limit temperature start fl ashing.
(The default value of the upper limit temperature is 38 °C.)
2. Press
and press
setting screen is displayed.
3. Press
and press
is completed. (The default value of the lower limit temperature
is 10 °C.)
* The unit returns to the normal mode if
3 minutes during the setting. In this case, all the settings in progress will be lost.
• Canceling the outing function
Press and hold
• Outing function indication
Outing function
indication
Off
Flashing
Lighting
Note
A remote controller loses outing function operation information when it is cut for more than one hour
during the outing function operation by electricity. It reverts from the blackout, and an air conditioner
does not drive in outing function when operation is started. At this time, an air conditioner does not stop
at outing function.
n.indb EN-12 n.indb EN-12
for more than 2 seconds to display
/ to select the upper limit temperature,
to fi x the value. The lower limit temperature
/ to select the lower limit temperature,
to fi x the value. The outing function setting
for more than 2 seconds while the outing function is set.
The outing function is not set.
The outing function is now being set, or under operation.
Although the outing function is set, not under operation.
is pressed or there is no operation made for
Status
EN-12
1 2,3
2 3
2,3
2011/ 2011/