Panasonic CZ-RTC2 Manuel D'instructions page 13

• Deleting the Program Timer
To delete the program timer setting, follow the steps below.
1. Press
2. Press
program you want to delete.
3. Press
4. Press to display the program setting mode
5. Press
Note
• After deleting, the unit returns to the program confi rmation
mode .
• If you press
program comfi rmation mode.
• If there is no operation made for 3 minutes during the setting, the unit returns to the normal mode.
• Invalidating Program Timer
If you want to adjourn the program operation for more than 1 week, you can invalidate all the timer settings.
Once the timer settings are invalidated, the program will not be operated until the invalidation is cancelled.
<<How to invalidate the program timer>>
Press and hold
is displayed and the programs will be invalidated from the next one.
<<How to cancel the program timer invalidation>>
Press and hold
disappears and the programs will be validated from the next one.
If Power Failure Occurred
If the power recovers in a short time period, the program after the recovered time will be valid.
If the power recovered more than 1 hour after the failure, the present time information will be lost. In this
case, the program will not be operated.
n.indb EN-9 n.indb EN-9
to enter the program confi rmation mode.
/ to select the day of the
/ to select a TIMER No. (from 1 to 6).
to delete the program.
during the setting, the unit returns to the
for more than 2 seconds.
for more than 2 seconds.
.
5
EN-9
3 4 1 2
EN
2011/ 2011/