Panasonic CZ-RTC2 Manuel D'instructions page 12

4. Weekly Program Function (Continued)
4. Set the program pattern.
(program step 3)
There are 4 program patterns.
Pressing
display patterns.
Pattern 1
The indoor unit starts operation at the
programmed time.
Pattern 2
The indoor unit stops operation at the
programmed time.
Pattern 3
The indoor unit starts operation at the
programmed time and changes the
temperature settings.
Press
temperature setting.
Pattern 4
The indoor unit changes the temperature
setting at the programmed time.
Press
temperature setting.
Select the program pattern and press
confi rmation mode
Note
• If you press
• If there is no operation made for 3 minutes during the setting, it returns to the normal mode.
In this case, all the settings in progress will be invalid.
n.indb EN-8 n.indb EN-8
/ repeats the following
/ to change the
/ to change the
.
during the setting, it returns to the program confi rmation mode.
. The program timer setting is confi rmed and the unit enters the
EN-8
Pattern 1
Pattern 2
Pattern 3
Pattern 4
2011/ 2011/